IMC Networks iMcV-T1/E1/J1-LineTerm Manual de Instruções Página 1

iMcV-T1/E1/J1-LineTerm Operation Manual

7 By default all Loopbacks are set to OFF for normal data operation. This feature can be controlled by SNMP–Management software (iView2) when the HOS

8 These standard Telco transmission pattern modes are provided to help diagnose transmission errors in the line. By default this feature is set to St

9 LED Operation The iMcV-T1/E1/J1-LineTerm module features several diagnostic LEDs per port. The following LED display functions are provided: Copp

10 Loopback Testing The iMcV-T1/E1/J1-LineTerm includes three Loopback test modes: Copper Loopback, Fiber Loopback and Internal Fiber Loopback. The

11 CentralOfficeCustomeriMcV-T1/E1/J1-LineTermiMcV-T1/E1/J1-LineTermCopper CopperFiberXNoneCopper LoopbackCopper Loopback on Host iMcV-T1/E1/J1-LineT

12 Installation Troubleshooting General Troubleshooting • The copper port can easily be tested using the internal PRBS signal generator and detector

13 The following table lists the pin configuration for the RJ-48 connector. Pin Signal 1 Receive Ring 2 Receive Tip 3 No Connection 4 Transmit Ring

14 Specifications Standards Compliance (T1, E1, J1): ANSI T1.102-1993 ANSI T1.107.1995 GR-820-CORE T1, E1, J1 Interface: T1 (1.544 Mbps +/- 32 ppm) E

15 Fiber Optic Cleaning Guidelines Fiber Optic transmitters and receivers are extremely susceptible to contamination by particles of dirt or dust, wh

16 WARNING! Integrated circuits and fiber optic components are extremely susceptible to electrostatic discharge damage. Do not handle these compon

ii FCC Radio Frequency Interference Statement This equipment has been tested and found to comply with the limits for a Class A computing device, pursu

17 Safety Certifications UL/CUL: Listed to Safety of Information Technology Equipment, including Electrical Business Equipment. CE: The products

19772 Pauling • Foothill Ranch, CA 92610-2611 USA TEL: (949) 465-3000 • FAX: (949) 465-3020 www.imcnetworks.com © 2010 IMC Networks.

iii Table of Contents FCC Radio Frequency Interference Statement... ii Warranty ...

1 About the iMcV-T1/E1/J1-LineTerm iMcV-T1/E1/J1-LineTerm is an SNMP-Manageable module that convert standard TDM-based copper transports ( T1, E1, J1)

2 Prerequisites The iMcV-T1/E1/J1-LineTerm conforms to any T1/E1/J1-based environment. Ensure all of the relevant information about the expected ins

3 Managed Modules The iMcV-T1/E1/J1-LineTerm modules are installed as a HOST-REMOTE pair and can be remotely managed when the HOST is installed in an

4 Unmanaged Modules Before installing the module in an unmanaged chassis, manually configure all of the desired DIP Switch selectable features. Modu

5 DIP Switch Settings (S2, S3) Switch Settings for Switch S2 T1/E1 Selection S2-1: OFF T1 Mode Selected default S2-1: ON E1 Mode Selected

6 Switch Settings for Switch S3 Jitter Attenuator Select S3-1: ON Place Jitter Attenuator on RCV Side S3-1: OFF Place Jitter Attenuator on