IMC Networks 858-11121 Manual de Instruções

IE-MultiWay Operation Manual

7 This function will delete ALL community strings. To selectively delete community strings, use iConfig to configure the device. Ending the Session

8 Commands List (Space Bar) The IE-MultiWay also includes several device-specific options. To access these options, press the Space Bar from the Ma

9 OAM (Operation and Administration Management) Two modes of operations control the OAM function, Passive and Active. Passive mode is default mode.

10 DIP Switch configuration DIP Switch Name Description Default Setting 1 Dual Enable dual channel OFF 2 1+1 Provides 1+1 protection with no

11 DC Terminal Block Wiring Instructions The IE-MultiWay can also be powered with the DC terminal block. From a power source, connect to any one pos

12 RJ-45 Data Port Pinout The following table lists the pin configuration for the RJ-45 Data connector. Pin Signal Name 1000M Signal Direction 10/

13 Specifications Ethernet Connections • SFP 1000 Base-X • SFP 100 Base –FX • SFP 10/100/1000 Copper (SGMII) • 10/100/1000 BaseT (Fixed Copper ports)

14 IMC Networks Technical Support Tel: (949) 465-3000 or (800) 624-1070 (in the U.S. and Canada); +32-16-550880 (Europe) Fax: (949) 465-3020

15 Electrostatic Discharge Precautions Electrostatic discharge (ESD) can cause damage to any product, add-in modules or stand alone units, containing

16 Safety Certifications UL/CUL: Listed to Safety of Information Technology Equipment, including Electrical Business Equipment. CE: The produ

ii FCC Radio Frequency Interference Statement Class A (using 48V Telco type power) This equipment has been tested and found to comply with the limits

19772 Pauling y Foothill Ranch, CA 92610-2611 USA TEL: (949) 465-3000 y FAX: (949) 465-3020 www.imcnetworks.com © 2010 IMC Networks. All

iii Table of Contents FCC Radio Frequency Interference Statement ...ii Warranty...

1 About the IE-MultiWay The IE-MultiWay is a standalone device providing two 10/100/1000Base-T copper ports and 2 SFP ports. The SFP ports support f

2 IE-MultiWay with optional DIN rail mount power supply SFP Ports The IE-MultiWay SFP ports support gigabit fiber SFPs, 100Mbps fiber SFPs, with o

3 Configuration Method Description When a fault is detected on the active line, all customer traffic is switched to the “SFP B” port. With non-Reve

4 Press Enter to open the main configuration screen. This screens allows the user to set the IP address and the destination IP address for traps w

5 Command List I = Enter new Saved Parameter Values P = Change the Password* T = Enter new Trap Destinations K = Remove All Trap Destinations C = Cre

6 Passwords are a way to make the management of the IMC Networks devices secure, but these password lists must be stored and maintained. If a passwo